CMD_CRC_FAIL
= (1) which is Command response received (but CRC
check failed)
DATA_CRC_FAIL
= (2) which is Data bock sent/received (CRC check
Failed)
CMD_RSP_TIMEOUT
= (3) which is Command response timeout
DATA_TIMEOUT
= (4) which is Data time out
TX_UNDERRUN
= (5) which is Transmit FIFO under-run
RX_OVERRUN
= (6) which is Receive FIFO over-run
START_BIT_ERR
= (7) which is Start bit not detected on all data
signals in widE bus mode
CMD_OUT_OF_RANGE
= (8) which is CMD's argument was out of range
ADDR_MISALIGNED
= (9) which is Misaligned address
BLOCK_LEN_ERR
= (10) which is
Transferred block length is not allowed for the card or the number of
transferred bytes does not match the block length
ERASE_SEQ_ERR
= (11) which is An
error in the sequence of erase command occurs
BAD_ERASE_PARAM
= (12) which is An
Invalid selection for erase groups
WRITE_PROT_VIOLATION
= (13) which is Attempt
to program a write protect block
LOCK_UNLOCK_FAILED
= (14) which is
Sequence or password error has been detected in unlock command or if there was
an attempt to access a locked card
COM_CRC_FAILED
= (15) which is CRC
check of the previous command failed
ILLEGAL_CMD
= (16) which is Command
is not legal for the card state
CARD_ECC_FAILED
= (17) which is Card
internal ECC was applied but failed to correct the data
CC_ERROR
= (18) which is
Internal card controller error
GENERAL_UNKNOWN_ERROR
= (19) which is General
or Unknown error
STREAM_READ_UNDERRUN
= (20) which is The
card could not sustain data transfer in stream read operation.
STREAM_WRITE_OVERRUN
= (21) which is The
card could not sustain data programming in stream mode
CID_CSD_OVERWRITE
= (22) which is CID/CSD
overwrite error
WP_ERASE_SKIP
= (23) which is only
partial address space was erased
CARD_ECC_DISABLED
= (24) which is Command
has been executed without using internal ECC
ERASE_RESET
= (25) which is Erase
sequence was cleared before executing because an out of erase sequence command
was received
AKE_SEQ_ERROR
= (26) which is Error
in sequence of authentication.
INVALID_VOLTRANGE
= (27)
ADDR_OUT_OF_RANGE
= (28)
SWITCH_ERROR
= (29)
SDIO_DISABLED
= (30)
SDIO_FUNCTION_BUSY
= (31)
SDIO_FUNCTION_FAILED
= (32)
SDIO_UNKNOWN_FUNCTION
= (33)
INTERNAL_ERROR = (34)
NOT_CONFIGURED = (35)
REQUEST_PENDING = (36)
REQUEST_NOT_APPLICABLE = (37)
INVALID_PARAMETER = (38)
UNSUPPORTED_FEATURE = (39)
UNSUPPORTED_HW = (40)
ERROR = (41)
OK = (42)
CMD1_TIMEOUT = (60)
