EMMC PRO ERROR LIST

CMD_CRC_FAIL                          =       (1)       which is Command response received (but CRC check failed)

DATA_CRC_FAIL                         =       (2)       which is Data bock sent/received (CRC check Failed)

CMD_RSP_TIMEOUT                       =       (3)       which is Command response timeout

DATA_TIMEOUT                          =       (4)       which is Data time out

TX_UNDERRUN                           =       (5)       which is Transmit FIFO under-run

RX_OVERRUN                            =       (6)       which is Receive FIFO over-run

START_BIT_ERR                         =       (7)       which is Start bit not detected on all data signals in widE bus mode

CMD_OUT_OF_RANGE                      =       (8)       which is CMD's argument was out of range

ADDR_MISALIGNED                       =       (9)       which is Misaligned address

BLOCK_LEN_ERR                         =       (10)    which is Transferred block length is not allowed for the card or the number of transferred bytes does not match the block length

ERASE_SEQ_ERR                         =       (11)    which is An error in the sequence of erase command occurs

BAD_ERASE_PARAM                       =       (12)    which is An Invalid selection for erase groups

WRITE_PROT_VIOLATION                  =       (13)    which is Attempt to program a write protect block

LOCK_UNLOCK_FAILED                    =       (14)    which is Sequence or password error has been detected in unlock command or if there was an attempt to access a locked card

COM_CRC_FAILED                        =       (15)    which is CRC check of the previous command failed

ILLEGAL_CMD                           =       (16)    which is Command is not legal for the card state

CARD_ECC_FAILED                       =       (17)    which is Card internal ECC was applied but failed to correct the data

CC_ERROR                              =       (18)    which is Internal card controller error

GENERAL_UNKNOWN_ERROR                 =       (19)    which is General or Unknown error

STREAM_READ_UNDERRUN                  =       (20)    which is The card could not sustain data transfer in stream read operation.

STREAM_WRITE_OVERRUN                  =       (21)    which is The card could not sustain data programming in stream mode

CID_CSD_OVERWRITE                     =       (22)    which is CID/CSD overwrite error

WP_ERASE_SKIP                         =       (23)    which is only partial address space was erased

CARD_ECC_DISABLED                     =       (24)    which is Command has been executed without using internal ECC

ERASE_RESET                           =       (25)    which is Erase sequence was cleared before executing because an out of erase sequence command was received

AKE_SEQ_ERROR                         =       (26)    which is Error in sequence of authentication.

INVALID_VOLTRANGE                     =       (27)   

ADDR_OUT_OF_RANGE                     =       (28)   

SWITCH_ERROR                          =       (29)   

SDIO_DISABLED                         =       (30)   

SDIO_FUNCTION_BUSY                    =       (31)   

SDIO_FUNCTION_FAILED                  =       (32)   

SDIO_UNKNOWN_FUNCTION                 =       (33)

INTERNAL_ERROR                        =       (34)    

NOT_CONFIGURED                        =       (35)    

REQUEST_PENDING                       =       (36)    

REQUEST_NOT_APPLICABLE                =       (37)    

INVALID_PARAMETER                     =       (38)    

UNSUPPORTED_FEATURE                   =       (39)    

UNSUPPORTED_HW                        =       (40)    

ERROR                                 =       (41)    

OK                                    =       (42)    

CMD1_TIMEOUT                          =       (60)